-40%

XR2206 Function Signal Generator DIY Kit Sine Output 1HZ-1MHZ + acrylic case USA

$ 4.06

Availability: 114 in stock
  • Refund will be given as: Money Back
  • Signal Generator Type: Function Generator
  • Brand: Unbranded/Generic
  • MPN: Does Not Apply
  • Custom Bundle: No
  • Country/Region of Manufacture: China
  • Condition: New
  • Return shipping will be paid by: Seller
  • Type: Function or Waveform Generator
  • Non-Domestic Product: No
  • Frequency Range: 1Hz-1MHz
  • Item must be returned within: 30 Days
  • All returns accepted: Returns Accepted
  • Modified Item: No

    Description

    Description:
    Voltage Supply: 9-12V DC Input
    Waveforms: Square, Sine & Triangle
    Impedance: 600 Ohm + 10%
    Frequency: 1Hz – 1MHz
    SINE WAVE
    Amplitude: 0 – 3V at 9V DC input
    Distortion: Less than 1% (at 1kHz)
    Flatness: +0.05dB 1Hz – 100kHz
    SQUARE WAVE
    Amplitude: 8V (no load) at 9V DC input
    Rise Time: Less than 50ns (at 1kHz)
    Fall Time: Less than 30ns (at 1kHz)
    Symmetry: Less than 5% (at 1kHz)
    TRIANGLE WAVE
    Amplitude: 0 – 3V at 9V DC input
    Linearity: Less than 1% (up to 100kHz) 10m
    The welding installation considerations, follow these steps:
    1. The components are welding the front board, from low to high principles, namely the first low welding components, such as, capacitor, resistor, diode, etc.
    2.Welding IC socket, terminal blocks, finally power socket, adjustable potentiometer.
    3.The back with a diagonal cutting pliers to cut short the pins as far as possible
    Debugging steps:
    1. After completion of welding on IC, XR2206, pay attention to the direction of IC, insert the might damage the chip!
    2. check the IC whether against, such as anti please timely correction.
    3. Insert the power supply, power supply for 5.5 * 2.1 port, inside outside is negative polarity. For 9-12 v power supply voltage. The waveform may not be stable for more than 12 v
    Using
    1. J1 jumper cap plug in, SIN/TRI blue terminals output sine wave (note J1, J2 can only insert one of)
    2. J2 jumper cap plug in, SIN/TRI blue terminals output triangular wave (note J1, J2 can only insert one of)
    3. SQU blue terminals output pulse
    4. AMP : Sine wave, triangle wave amplitude adjustment
    5. FINE : Frequency fine adjustment
    6. Coarse : Frequency of coarse adjustment
    Package Included:
    1 x XR2206 Function Generator DIY Kit Sine, Triangle, Square Output 1HZ-1MHZ (
    soldering required)
    1 x Acrylic case
    (
    needs to be assembled
    )
    1 x Schematic diagram
    We don't provide technical assistance please make sure that you are familiar with the product before purchasing.
    * 9V Power Supply is not included, if you need one please add to the cart -
    https://www.ebay.com/itm/324319277082