HP Agilent Keysight 8341B Synthesized Sweep Signal Generator, 10MHz to 20GHz

Description

HP Agilent Keysight 8341B Synthesized Sweep Signal Generator, 10MHz to 20GHz
The two front handles shown in the pictures are not included.
S/N 2928A03058.   May 11 1988 firmware.
Self tests pass except for:
test 17 marker ramp
test 20 bnd cross dac
test 21 swp width dac
test 22 swp range atn
test 29 swweptime dac
Option 004: Rear panel RF output with 90 dB programmable attenuator
Testing performed:
8341B set to 500Mhz @ -40dBm:  FSIQ measured  500Mhz @ -15dBm  (25dBm difference)
8341B set to 500Mhz @ -80dBm:  FSIQ measured  500Mhz @ -55dBm (25dBm difference)
8341B set to 2Ghz @ -40dBm:  FSIQ measured  ~2Ghz @ -15dBm (25dBm difference)
Any frequency settings above 2.299GHz results in no noticeable output.
The "7", "8", and "Ghz" buttons are not working.
One lower bar of one digit on one of the digital Frequency displays is not lighting up.
This unit was very dirty as received. Spent about 3 hours cleaning the exterior. Installed new fan filter.  Fan is working good.
Some of the front and rear metal shows a fair amount of oxidation/corrosion.  Any connector shown with a protective cap had that cap installed while this unit was in use before I obtained it.  The rear RF output and HPIB connectors had cables connected so they were protected.
I removed one of the side panels and looked inside. The parts inside there look like no oxidation but I didn't remove all the covers to look everywhere.
Sold as not working for parts.
No cables or FSIQ included.
Very heavy item.  May not ship to your door if you have a residential address. You may have to pickup at Fedex if you have a residential address.